SARK V4.0.0 Trunk

From sailpbx
Revision as of 10:58, 8 January 2013 by Adminwiki (talk | contribs)
Jump to: navigation, search

back to SARK v4.0.0 contents

Adding Trunks

Outbound trunks for your installed hardware and a general inbound trunk class are automatically installed on the platform so there is nothing to do to activate them. You will probably wish/need to create additional inbound and outbound routing (see Routes below) to handle DDI's, ACD and IVR requirements.

If you are running FXO channels, (or BRI without DNID presentation) then inbound calls will automatically be delivered to the 'operator' entry specified in the globals panel. The system default for the operator is to point to a ring group called RINGALL which simply rings all phones; you can, of course update this to point to another call-group, queue or IVR.

Inbound Routing

The routing of inbound calls falls into one of two categories; you can route by the Dialled Number ID (DNID) if you have digital lines with DNID enabled or VoIP lines. In the case of FXO(pots) lines you can route by channel name/number.

digital and IP

To route inbound Digital calls with DNID enabled,simply create one or more DiD (DDI) trunks to route the inbound calls. (see the next section). You may need to confirm with your telephone line supplier (PTT) how many digits will be presented in the DNID (it may be 3 or more digits depending upon your carrier's practice).

FXO(pots)

To route individual FXO channels you can set up a custom trunks and name them fxo{n}; where {n} is the port number on the tdm card.