SARK 200 - SARK preinstalled on ARM

From sailpbx
Revision as of 17:18, 10 March 2013 by Adminwiki (talk | contribs)
Jump to: navigation, search

SARK 200 ARM

Sark 200 Front 2 300x400.png

The SARK200 is an ultra-low power consumption embedded PBX running on a GHz ARM chip. The appliance is small enough to fit in the palm of your hand but it is a fully featured SARK device and it will support up to 12 endpoints and 8 concurrent calls. It also supports Zero Touch Provisioning for PnP (SIP Multicast) capable handsets as well as advabnced features such as on-board conferencing and call recording.

Key Features

  • Unlimited inbound DDIs
  • Unlimited voice mailboxes
  • Voicemail-to-email (Unified communications)
  • up to 8 hours of Voicemail storage
  • Call-management; hold, transfer forward
  • Customisable auto-attendant
  • True Hot Desking feature
  • Up to 128 Pickup Groups
  • Unlimited call/hunt/page groups
  • Flexible day/night modes
  • Full featured call queuing
  • Multiple Conference bridges
  • Music on Hold
  • Web based configuration and management
  • Powerful, yet simple, on-board firewall
  • Support for SIP and IAX trunking
  • Optional TAPI module for Windows integration

Hardware

  • Ultra-low power consumption; typically 2.3w-7w.
  • Resilient solid state design with no moving parts
  • silent operation
  • onboard 100-240 VAC switching power supply
  • 1.2GHz ARM CPU
  • 512MB on-board RAM.
  • 4GB on-board MMC
  • single Gb Ethernet
  • 1xUSB2
  • 1xMiniUSB engineering serial console

Quickstart

What's in the box?

Img 0176 400x300.jpg

The unit is delivered with the following (see photo):-

  • "figure eight" power cord
  • Engineer's (black) serial USB2 to MiniUSB lead
  • Cat 5 patch lead
  • 4GB SD flash memory card

Pre Power-up

The unit requires that the SD card be inserted prior to power up. The SD card is inserted into the SD card slot. The slot is located on the left face of the device bwteen the MiniUSB port and the reset pin-hole. The card should be oriented face down (as shown in the picture below).

Image showing SD Card ready to be inserted

Img 0182 400x300.jpg

Once inserted, the device should look like the picture below. In this image you can see the SD Card correctly inserted with the MiniUSB port to the right and (somewhat less clearly), the reset pin-hole to the left.

Image showing SD Card inserted

Img 0195 400x300.jpg


Power Up

You can now attach the device to the local network using the RJ45 patch cable provided or any regular RJ45 ethernet patch lead. Insert the figure eight power cord into the base of the unit and plug it into the mains (100-240VAC). The unit will power up and come on-line in about 1 minute.

Img 0188 400x300.jpg